99 vx with 33x12.5x15 aethon m/t,s on ultra 164 aluminum plastic dipped 15in wheels 8 inch wide 3.724 backspace, -18 offset. Torsion bars tightened...99 vx with 33x12.5x15 aethon m/t,s on ultra 164 aluminum plastic dipped 15in wheels 8 inch wide 3.724 backspace, -18 offset. Torsion bars tightened 9 full turns which lifted it 3 inches. Just found out iam getting my sunroof replaced for free. Due to a recall for webasto hollindia model 600 and 700. Check it out. You might be eligible too. Thought I'd share. 1/17/2021. Show more

When the axel lock sleve is in lock position the indicator light will come on. When its unlocked the light goes out. No guessing and true 2 hi or...When the axel lock sleve is in lock position the indicator light will come on. When its unlocked the light goes out. No guessing and true 2 hi or low. 4 lo lock and or tod high. That simple. Show more

Hook the two vacume lines up at the diaphragm on the driver side front axel and run them through the firewall and along the console to front of...Hook the two vacume lines up at the diaphragm on the driver side front axel and run them through the firewall and along the console to front of driver seat. A simple hand pump will have to be switched from one line to the other for locking and unlocking. The two ground wires need to go from the continuity switch next to the diaphragm, ground one, hook other to ind. Light, plug add a cir fuse box Show more

True 2 wheel hi and low mod. Without manuel locking hubs. And without fault lights or codes. Here's all you need. 2 eight foot vacume lines. One six...True 2 wheel hi and low mod. Without manuel locking hubs. And without fault lights or codes. Here's all you need. 2 eight foot vacume lines. One six and one four foot ground wires. One indicator light. And one mini add a circuit that just plugs into you're fuse box. And any type of manuel vacume acuator. (Even a syringe used for injecting butter in turkeys will work.)... simple installation next Show more

Does anyone know how to contact an isuzu parts guy named Merlin. I been trying to figure out why I cant get power to my front drive shafts/wheels. I...Does anyone know how to contact an isuzu parts guy named Merlin. I been trying to figure out why I cant get power to my front drive shafts/wheels. I recently installed a transmission in my vx out of a 1998 trooper. Everything appears good. No trouble codes. Tod indicated works like it should. I finally found a thread that claimed vx and trooper tc's are not interchangable Show more

I have an issue with my 99 vx.i recently installed a tranny out of a 98 trooper. The tod indicator works exactly as it should. It doesnt flash. It...I have an issue with my 99 vx.i recently installed a tranny out of a 98 trooper. The tod indicator works exactly as it should. It doesnt flash. It showes the correct % in 2hi and 4 low. But it wont lock in. Front propeller (driveline) spins, but not engaging. Its showing 13,21,24,27 code faults which i am trying to figure out how to address. Power ground, and speed sensor issues. ... Show more

Hello fellow vx fans. I am new. I had never seen a vehicross until march of 2019 and it was love at first sight. I found a great deal on one in need...Hello fellow vx fans. I am new. I had never seen a vehicross until march of 2019 and it was love at first sight. I found a great deal on one in need of repair and within a few weeks drove to nampa idaho and trailered my 1999 ebony black, with red interior and went to work. I found a 1998 trooper with a blown motor in Portland brought it back to kennewick washington and started swapping parts. Show more